My First Rc

I just bought my first nitro RC car and i cannot get to start. I am sure the candles are working and I put the finger on the exhaust gas so that some goes into the engine and all electrical components are connected and working properly. No mater how much I pull the starter of the car does not start.
can help any one?

follow the instructions with your engine ... prime the engine, make sure your hot water preheating is charged, idle open, mixing, plug tight head on tight.
DONT above the prime rate, you can "Hydrolock" condition.

could be flooded if so ... remove the spark plug and pull the pullstart all the fuel left Flag

try to close the valve needle down if it comes to the amount of fuel if they want to plug some fuel it wont run either.

this type of engine is it?