A guide to installing a replacement liner overlap to a low level above ground swimming pool. Although there are several methods that can be tried, what seems to be the easiest way and less risk. We also have some tips for pre-employment. Screw the top rails and plates may be rusty. Have a can of WD-40 on hand for relaxation. Also, wasps LOVE to hide under top rails. Cautiously eliminate the wasps with wasp spray your favorites.
Do flat bottom pool liners in sunny, 75 degrees plus, the weather. Pool liners install dished or expandable under the sun, 85 degrees weather. Only fill pools during the day. Check your pool and pool liner overlap that often fills with water. Completely inspect the pool liner before starting the installation. Once you start to install it, you own, including all defects.
Drain your old pool. Remember that when the water is gone, your pool is sensitive to strong winds. If your pool is in the ground a few inches longer, stay away from the pool as much as possible so that you do not give in to the dirt and push the wall in.
Without removing the rails, cut the old pool liner. There will be a thin strip of liner at the top left of the wall lying on top of the wall. This will be removed at a later stage.
Address of the pool bottom. Remove all roots, stones or sharp objects that could puncture the pool liner new. Installation of replacement sand or vermiculite, if necessary. Make sure the handle to the inside of the pool wall is firm, stable and in good condition. If it has compressed or washed away over the years, re-build. Most manufacturers recommend a loop of six inches high.
Make sure the skimmer and return holes are in good condition. All areas of rust should be lightly sanded and painted with a proprietary rust. Make sure that the residue does not mix with sand in the ground inside the pool.
Carefully open the box new line pool. DO NOT use a knife or other sharp object! Make sure the liner is the right size to fit your pool. There is no return for a pool liner if the box has been opened. If possible, unfold the liner of the pool in your garden. Make sure there is nothing to puncture. If necessary, you can unfold the liner inside the pool. Once opened, roll the pool line length of paths, then fold it in half. With help, carefully lift the cover on the wall and place it inside the pool.
Remove shoes and make sure your fingernails and toenails are well trimmed.
With another person inside the pool, unroll the liner and position into place. Use the seam that connects the side and bottom of the liner as a guide, keeping the seam equal distance from the wall. There may be a little variation if the pool is a bit out of shape. Most pools are a bit out of shape. But remember that once you've put a lot of water on the pool liner, it will not budge.
Smooth the liner overlap as much information as possible.
Delete all three consecutive sections of top rail and the adaptation and remnants of old steamer.
Using the old plastic coping or spring-style clothes, put the canvas on the wall a few inches and secure. Do not worry if the sides of the shirt are cowards. Be careful not to snag the liner on the edges of the rails above.
Spending a few sections and number, repeat step 10. Continue until the coating is on the wall across the entire pool. Some higher amounts will always be on the pool surface and will not be on the wall at these points. Good. If you wish, you can place a prot.
How to change an overlap pool liner for above ground? 
